top of page

ELAC’s Miracord 50 Turntable is designed to deliver exceptional vinyl transcription, inspired by the iconic Miracord name from the Golden Age of Stereo, when turntables reigned supreme. The Miracord 50 is carefully engineered with a belt-drive motor and die-cast aluminum platter. A precision static balanced, straight-tube tonearm with removable headshell features a factory-mounted MM phono cartridge. Designed with convenience in mind, the Miracord 50 is equipped with a built-in defeatable phono preamplifier, allowing you to add this turntable to virtually any music system.

ELAC Miracord 50 Turntable


Turntable Section

Drive System Belt drive
Motor DC motor
Selectable Speeds 33⅓ and 45 rpm
Motor Servo Speed rotation and servo system
Rotation Speed Variation +/-1%
Wow and Flutter 1%
Signal-to-Noise Ratio -67 dB or higher (A-weighted) -60 dB or higher (unweighted)
Platter Aluminum die-cast
Platter Diameter 0 in / 300 mm

Tonearm Section

Type Aluminum tube, static-balanced
Effective Arm Length 8 in / 223.6 mm
Stylus Pressure Range 0 to 0 g
Cartridge Weight Range 5 to 6.0 g
Effective Arm Mass 4 g
Overhang 6 mm
Offset Angle 25 degrees
Anti-Skating Adjustment Supported
Main Bearing Stainless steel

Cartridge Section

Type Audio-Technica AT91 moving magnet
Stylus Construction Bonded diamond
Mount Half-inch
Frequency Response 20 Hz to 20 kHz
Channel Separation >18 dB
Channel Balance 5 dB
Vertical Tracking Angle 20 degrees
Stylus Pressure 0 g +/-0.5 g
Cartridge Weight 0 g +/-0.5 g
Headshell Weight 0 g (including screws, nuts and wires)

Phono Equaliser Amplifier

Type Moving magnet (MM)
Phono Output 5 mV (1 kHz, 3.54 cm/sec)
Line Output 140 mV (-17 dBV)
Phono/Line Switchable
Supported Load Impedance 47 kΩ


Connector RCA pin jack including RCA cable accessories
Voltage 100 to 240 V AC / 50 to 60 Hz
Power Consumption 1.5 W (less than 0.5 W at standby)
Dimensions (W x H x D) 5.5 x 16.05 x 14.20
Weight 12.10 lb
bottom of page